ZyXEL Communications P-2602HWNLI Support Notes page 100

not knowing what your MAC address is, please enter a command "ipconfig /all" after DOS prompt to get the
MAC (physical) address of your wireless client.
If you use SMT management, the MAC Address Filter configuration are as shown below.
Enter the MAC Addresses of wireless cards in the filter set to allow or deny association from these cards.
------------------------------------------------------------------------------
1= 11:11:11:11:11:11
2= 00:00:00:00:00:00
3= 00:00:00:00:00:00
4= 00:00:00:00:00:00
5= 00:00:00:00:00:00
6= 00:00:00:00:00:00
7= 00:00:00:00:00:00
8= 00:00:00:00:00:00
9= 00:00:00:00:00:00
10= 00:00:00:00:00:00
11= 00:00:00:00:00:00
12= 00:00:00:00:00:00
------------------------------------------------------------------------------
Key Settings:
Option Descriptions
Allow or block association from MAC addresses contained in this list. If Allow Association
is selected in this field, hosts with MAC addresses configured in this list will be allowed to
Filter Action
associate with AP. If Deny Association is selected in this field, hosts with MAC addresses
configured in this list will be blocked.
Menu 3.5.1 - WLAN MAC Address Filter
Active= Yes
Filter Action= Allowed Association
13=
14=
15=
16=
17=
18=
19=
20=
21=
22=
23=
24=
Enter here to CONFIRM or ESC to CANCEL:
All contents copyright (c) 2006 ZyXEL Communications Corporation.
P-2602HWNLI Support Notes
00:00:00:00:00:00 25=
00:00:00:00:00:00 26=
00:00:00:00:00:00 27=
00:00:00:00:00:00 28=
00:00:00:00:00:00 29=
00:00:00:00:00:00 30=
00:00:00:00:00:00 31=
00:00:00:00:00:00 32=
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
100