Table of Contents
Advertisement
P-2602HWNLI Support Notes
Relay to PSTN
The Relay to PSTN field can be found under PSTN configuration WEB GUI in Relay to PSTN section. This
field is used to specify phone numbers to which the Prestige will always send calls through the regular PSTN
phone service without pushing prefix. In other words, numbers which specify on this field do not need to dial
prefix number to be dialed out. However, these numbers must be for phones on the PSTN (not VOIP phones)
and currently, P2602WNLI support up to nine entries under this field.
After configuring the PSTN setup, click "Apply＂ to save changes back to P2602WNLI.
Note: It is recommended to configure your local emergency services such as Police Dept, Fire Dept, and
Emergency Medical services phone number in this field. Thus in any cases, these unit can be reach in case of
emergency by dialing their number without prefix, regardless if there are power loss.
How to connect Lifeline and DSL connection
To use both VOIP and regular phone service with P2602WNLI＇s lifeline feature. You will need to connect
ADSL line and phone line appropriately and make proper configuration.
Making the correct connection it allows you to still receive phone calls while someone else is making outgoing
VoIP call though Prestige＇s 2 pots port, the following figure shows you how to connect your phone and DSL
service.
If your ADSL line type is Splitter type you ISP will provide you with splitter otherwise it should be splitterless.
For correct info you may check with your service provider as for which type of line you have.
127
All contents copyright (c) 2006 ZyXEL Communications Corporation.
Advertisement
Table of Contents
