CONTENTS Page CERTIFICATE OF CONFORMITY INTRODUCTION SAFETY INSTRUCTIONS ASSEMBLING THE MACHINE OPERATING THE MACHINE SAFETY INTERLOCK SWITCHES TO START THE ENGINE TO STOP THE ENGINE STEERING WORKING INSTRUCTIONS CUTTING WITH THE MACHINE CYLINDER DRIVE CLUTCH SPEED CONTROL THROTTLE CONTROL BRAKE & PARKING BRAKE LIFTING &...
CERTIFICATE OF CONFORMITY I, the undersigned, Mr J. Allen of Allen Power Equipment Ltd., The Broadway, Didcot, Oxon OX11 8ES, certify that the machine described below: Category Lawnmower Make ALLEN Type Ride-on Model Turf Trooper II Cutter 60” (1530mm) Cylinder comply with the following Directives.
INTRODUCTION SAFETY INSTRUCTIONS The ALLEN TURF TROOPER 2 is an advanced Please ensure that the instructions contained ride-on cylinder mower designed to cut grass in this manual are read carefully and fully quickly, efficiently and economically, giving your understood by any person likely to operate lawn the velvet finish only a quality cylinder the Trooper.
Locate and secure the seat. party through operational negligence. Fill and charge the battery, fuel and oil the Allen Power Equipment Limited reserve the right engine. to alter specifications and prices as and when necessary Run the machine and check that all the necessary functions perform correctly.
SAFETY INTERLOCK SWITCHES the Cylinder Drive (lever) ‘G’, Fig. 5 is disengaged. The machine is fitted with a number of interlock Release the Parking Brake ‘H’, Fig. 6 and switches to give additional safety to the customer. Here are some tips relating to the use of the depress the Drive Pedal ‘F’, Fig.
units. With the lever ‘G’ in the lowered position. FRONT CYLINDERS Fig. 8, the drive is disconnected and it should always be in this position when stopping the To Lower machine. Each front unit has a lift handle and a latch ‘K’, With the engine running, the Cylinder Drive may Fig.
If working on lifted parts ensure that adequate Use Castrol L.M. grease or equivalent. support is provided. Occasionally lubricate all other moving parts by oil Do not alter engine speed above the maximum can, in particular the Throttle Control at the lever quoted in the engine specification.
If belt replacement is necessary, remove the CYLINDER CLUTCH ADJUSTMENT main access panel as detailed above. Then remove the Locating Spigot Bar from the The clutch is designed to be partially self- fan/pulley assembly, Fig. 14 and separate the adjusting, however periodic inspection should be fan/pulley assembly, Fig.
45 days), blade will not be improved by tightening the cylinder to the bottom blade. In such cases the ALLEN POWER EQUIPMENT LTD undertake to replace the faulty component/components free of cylinder/bottom blade needs to be sharpened.
Need help?
Do you have a question about the Turf Trooper II and is the answer not in the manual?
Questions and answers