Label Locations; Invacare Transport, Lightweight Transport, And Lite Transport - Invacare Transport Owner's Operator And Maintenance Manual

LABEL LOCATIONS

Invacare Transport, Lightweight Transport, and Lite
Transport
NOTE: The Lightweight transport is shown as an example. Unless indicated on this page, label
locations and wording are the same for the Invacare transport and the Lite transport.
NOTE: This label is only on the
Lite transport.
View From Back of Chair
NO TRANSPORT CHAIR HAS BEEN APPROVED FOR USE AS A
SEATING SURFACE WITHIN A MOTOR VEHICLE. THIS LABEL IS FOR
INFORMATIONAL PURPOSES ONLY. LIABILITY ISSUES WERE NOT
CONSIDERED IN THE ATTACHMENT OF THIS LABEL.
AUCUNE CHAISE ROULANTE N'A ETE APPROUVEE POUR UTILISATION COMME
SIEGE DANS UN VEHICULE MOTORISE. CETTE ETIQUETTE EST POUR INFORMATION
UNIQUEMENT. LES QUESTIONS DE RESPONSABILITE N'ONT PAS ETE PRISES
EN LIGNE DE COMPTE DANS LE CADRE DE L'APPLICATION
DE CETTE ETIQUETTE.
Transport Chairs
LABEL LOCATIONS
1143180 Rev A - 4/26/06
The wheel locks on this transport chair have
been pre-set at the factory to comply with the
Veterans Administration functional Standard
8320.01 of the Federal Register, paragraph
3.2.4.5.3. If these wheel locks do not meet
your needs, follow instructions below.
!
Any wheel lock adjustments should embed
wheel lock shoe at least 1/8" into tire when
locked (3/16" on pneumatic tires).
INSTRUCTIONS FOR WHEEL
LOCK ADJUSTMENTS
1. Loosen wheel lock mounting fastener,
which runs through mounting bracket and
frame.
2. Slide clamp toward rear wheel until wheel
lock shoe is embedded into tire material at
least 1/8" when handle is engaged to the
lock position (3/16" for pneumatic tires).
3. Tighten mounting fastener to secure
mounting bracket in desired location and
recheck lock shoe embedding.
4. Inspect for correct locking action BEFORE
actual use.
8
IMPORTANT NOTICE
CAUTION
P/N 1143193 REV A
Part No.1125095