To Use Wood Chip Loader - Masterbuilt 70070106 DIGITAL SMOKEHOUSE Assembly, Care & Use Manual

ASSEMBLY INSTRUCTIONS Continued
Smoker is ready to use.
7
Step 7
Slide cooking racks onto guides
inside smoker.
Step 8
Slide brackets on back of grease tray
onto tabs on back of smoker body
until grease tray stops.
HOW TO USE WOOD CHIP LOADER
Load
Unload
Unload
When door is opened a flare up may occur. Should wood chips flare up, immediately close
door, wait for wood chips to burn down then open door again. Do not spray with water.
Pre-soak wood chips for at least
30 minutes.
When smoker reaches desired
temperature place 1 cup of wood
chips in wood chip loader.
Never use more than 1 cup of
wood chips at a time.
Insert wood chip loader into smoker.
Wood chips should be level with top
rim of wood chip loader.
Turn handle to "Unload" mark on
smoker. Wood will drop onto wood
chip holder. Turn handle to "Load"
and leave wood chip loader in place
inside smoker.
Check wood chip holder periodically
to see if wood has burned down by
removing wood chip loader and
looking into smoker through hole.
Add more chips as needed.
Wood chip loader must be pulled out
completely from smoker when
checking wood chip level.
Adding more wood during
smoking process:
Caution: Keep smoker door closed
when adding wood chips.
Note: Wood chip loader will be HOT
even if handle is not.
To add wood, turn handle to "Load"
mark on smoker.
Load
Pull wood chip loader from smoker.
Place wood chips in wood chip
loader and re-insert into smoker.
Turn handle to "Unload" mark on
smoker. Wood will drop onto wood
chip holder.
Temperature may spike briefly after
wood is added. It will stabilize after
a short time. Do not adjust.
CAUTION
8