Techni-Lux HMI 1200W/S XS User Manual page 10

DIMM/SHUTT (to select dimmer mode, timeout)
To select the dimmer/shutter options press OK.
It is possible to select the dimmer mode (MOD1/MOD2) the shutter mode (MOD1/MOD2), the insertion of the shutter during the
color change and the shutter change, the time-out when the DMX signal it is not present. To go back to the options without making
any change, press the ESC button.
HRS COUNT (To visualize the values of the counters)
To visualise the number of hours of the fixture and of the lamp OK.
It is only possible to show the counters, all the keys is used to go back to the options without making any change.
DISPLAY (to flip the displays, to control the brightness)
To select the options of the display press OK.
It is possible to choice the FLIP option, the auto-shutdown of the display and to control the brightness of the control panel. To go
back to the options without making any change, press the OK button.
UTILITY (to visualize the DMX values, to select the demo mode, to choiche the language)
To visualise the utilities, to choice the language, the demo mode and the test of the fixture press OK.
Use Down and Up buttons to change the mode and, once the required one has been selected, press and keep ENTER pressed up to
when the display stops flashing (it flashes to indicate that the selected option is different from the pre-set one). It is possible to set:
no (normal) normal pan, PI (pan inversion). To go back to the options without making any change, press the MENU button.
DMX SPEC (to activate/deactivate the reset of the fixture, the control of the lamp control and to selct the ramp by the DMX con-
troller)
To choice the DMX options press OK.
It is possible to activate the remote reset of the fixture (Rese), the remote switch-off of the lamp and theremote selection of the ramp.
To go back to the options without making any change, press the OK button.
SERVICE (to calibration of the wheels)
To reset the counter of the lamp and to calibrate the wheels press OK.
The sub-menu will be showed: Format, reset lamps hours and calibration. The calibration has two possible choices: Calibrat 1 and
Calibrat 2. Ref. to page 9 for details. The offset is the value added to the reset position of the wheel so to change the position of the
wheel after the reset procedure. These values will be stored in the flash memory of the fixtures.
To go back to the options without making any change, press the MENU button.
BALLAST (to modify the options of the electronic ballast)
To verify the working parameters of the lamp and to change the type of the lamp press OK.
The showed parameters are: the voltage, the current, the PFC voltage, the effective power of the lamp, the number of the possible
tentative to strike the lamp and the lamp's type.
In the advanced menu it is possible to modify the number of the strikes and the lamp's type.
To go back to the options without making any change, press the OK button.
... 9 ...