Firmware/Configurations Uploading And Downloading Using Tftp; Using Tftp Client Software - ZyXEL Communications P-662HW-D Series Support Notes

2. Firmware/Configurations Uploading and Downloading using TFTP

• Using TFTP client software

• Upload/download ZyNOS via LAN
• Upload/download Prestige configurations via LAN
(1) Using TFTP to upload/download ZyNOS via LAN
Step 1: TELNET to your Prestige first before running the TFTP software
Step 2: Type the CI command 'sys stdio 0' to disable console idle timeout
in Command Line Interface (CLI)
Step 3: Run the TFTP client software
Step 4: Enter the IP address of the Prestige
Step 5:To upload the firmware, please save the remote file as 'ras' to
Prestige. After the transfer is complete, the Prestige will program the upgraded
firmware into FLASH ROM and reboot itself.
An example:
The 192.168.1.1 is the IP address of the Prestige. The local file is the source
file of the ZyNOS firmware that is available in your hard disk. The remote file is
the file name that will be saved in Prestige. Check the port number 69 and
512-Octet blocks for TFTP. Check 'Binary' mode for file transfering.
(2) Using TFTP to upload/download SMT configurations via LAN
Step 1: TELNET to your Prestige first before running the TFTP software
Step 2: Type the command 'sys stdio 0' to disable console idle timeout in
Command Line Interface (CLI).
Step 3: Run the TFTP client software
All contents copyright © 2006 ZyXEL Communications Corporation.
P-662HW-D Series Support Notes
137