ZyXEL Communications P-662HW-D Series Support Notes page 92

services of the line will be. After that, system will save back the correct VPI,
VCI and also services (encapsulation) type into profile of WAN interface.
• Configure the VC auto-hunting preconfigured table.
(1) Display auto-haunting preconfigured table by using command from CLI:
wan atm vchunt disp
(2) Add items to the auto-haunting preconfigured table by using commands:
wan atm vchunt add <remoteNodeIndex> <vpi> <vci> <service
bit(hex)>
wan atm vchunt save
Note: <remote node> : input the remote node index 1-8
<vpi> : vpi value
<vci> : vci value
<service>: it's a hex value, bit0:PPPoE/VC (1), bit1:PPPoE/LLC (2) ,
bit2:PPPoA/VC (4), bit3:PPPoA/LLC (8), bit4:Enet/VC (16), bit5 :Enet/LLC (32)
For example:
(1) If you need service PPPoE/LLC and Enet/LLC then the service bits will be
2+32 = 34 (decimal) = 22 (hex), you must input 22
(2) If you want to enable all service for VC hunting, the service bits will be
1+2+4+8+16+32=63(decimal)= 3f (hex), you must input 3f
Need to perform save after this by command 'wan atm vchunt save'
All contents copyright © 2006 ZyXEL Communications Corporation.
P-662HW-D Series Support Notes
91