General Control - Sharp HT-SB30D Operation Manual

General control

■ To turn the power on
Press the ON/STANDBY button.
The INPUT indicator lights up.
Note:
If the power does not turn on, check whether
the power cord is plugged in properly.
To set the sound bar to standby mode:
Press the ON/STANDBY button again. The
PAIRING indicator turns BLUE.
■ Bluetooth standby mode
The first time the unit is plugged in, it
●
will enter the Bluetooth standby mode
(PAIRING indicator turns BLUE).
To cancel the Bluetooth standby mode,
●
press and hold the ON/STANDBY button
during Bluetooth standby mode. The unit
will enter the low power consumption
mode (PAIRING indicator turns off).
To return to the Bluetooth standby mode,
●
press the ON/STANDBY button again.
During Bluetooth standby condition, NFC
●
function is activated once your device
touches the NFC detection area or the
supplied NFC tag.
■ Volume auto fade-in
If you turn off and on the sound bar again,
volume will start at lower level and gradually
increase to the last set level.
■ Volume control
Sound bar operation:
Press volume up (VOLUME + ) to increase the
volume and press volume down (VOLUME – )
to decrease the volume.
Remote control operation:
Press the VOL + button to increase the volume
and the VOL – button to decrease the volume.
Notes:
When volume is maximum or minimum the
●
SURROUND indicator blinks 3 times
To increase or decrease the volume
●
continuously, press and hold the VOLUME
+/- buttons (main unit) or VOL +/- buttons
(remote control).
■ Muting
The volume is muted temporarily when
pressing the MUTE button on the remote
control (SURROUND indicator blinking).
Press again to restore the volume.
■ Surround
When the SURROUND button is pressed,
the SURROUND sound is ON. (SURROUND
indicator lights up (ORANGE))
■ Sound Mode
Remote control operation:
Press the desired sound mode button on the
remote control.
The SURROUND indicator blinks once
CINEMA (for cinema sound effect)
MUSIC (for standard sound effect)
NEWS (for news)
BYPASS (for flat sound effect)
■ Function
When the INPUT button is pressed, the input
source will change.
1 Optical In Function - the INPUT indicator
turns green.
2 Audio In Function - the INPUT indicator
turns cyan.
3 Bluetooth Function - the INPUT
indicator turns blue.
Note:
The backup function will protect the
memorized function mode for a few hours
should there be a power failure or the AC
power cord becomes disconnected.
E-13