Sharp HT-SB30D Operation Manual page 4

IMPORTANT SAFETY
INSTRUCTIONS (continued)
21) Wall or ceiling mounting - When mounting the
product on a wall or ceiling, be sure to install the
product according to the method recommended
by the manufacturer.
22) Power Lines - An outside antenna system should
not be located in the vicinity of overhead power
lines or other electric light or power circuits, or
where it can fall into such power lines or circuits.
When installing an outside antenna system, ex-
treme care should be taken to keep from touch-
ing such power lines or circuits as contact with
them might be fatal.
23) Protective Attachment Plug - The product is
equipped with an attachment plug having over-
load protection. This is a safety feature. See
Instruction Manual for replacement or resetting
of protective device. If replacement of the plug
is required, be sure the service technician has
used a replacement plug specified by the manu-
facturer that has the same overload protection as
the original plug.
24) Stand - Do not place the product on an unstable
cart, stand, tripod or table. Placing the product on
an unstable base can cause the product to fall,
resulting in serious personal injuries as well as
damage to the product. Use only a cart, stand,
tripod, bracket or table recommended by the
manufacturer or sold with the product. When
mounting the product on a wall, be sure to fol-
low the manufacturer's instructions. Use only the
mounting hardware recommended by the manu-
facturer.
Precautions
■ General
Please ensure that the equipment is positioned in
●
a well-ventilated area and ensure that there is at
least 4" (10 cm) of free space along the sides and
top of the equipment.
4" (10 cm)
Use the unit on a firm, level surface free from
●
vibration.
Keep the unit away from direct sunlight, strong
●
magnetic fields, excessive dust, humidity and
electronic/electrical equipment (home computers,
facsimiles, etc.) which generate electrical noise.
Do not place anything on top of the unit.
●
Do not expose the unit to moisture, to tempera-
●
tures higher than 140°F (60°C) or to extremely
low temperatures.
If your system does not work properly, disconnect
●
the AC power cord from the AC outlet and replug.
In case of an electrical storm, unplug the unit for
●
safety.
Hold the AC power plug by the head when remov-
●
ing it from the AC outlet, as pulling the cord can
damage internal wires.
The AC power plug is used as a disconnect de-
●
vice and shall always remain readily operable.
Do not remove the outer cover, as this may
●
result in electric shock. Refer internal service
to your local SHARP service facility.
This unit should only be used within the range of
●
41°F - 95°F (5°C - 35°C).
SHARP is not responsible for damage due to
●
improper use. Refer all servicing to a SHARP
authorised service center.
Warning:
The supplied AC/DC adaptor contains no user
●
serviceable parts. Never remove covers unless
qualified to do so. It contains dangerous voltages,
always remove mains plug from the main outlet
socket before any service operation or when not
in use for a long period.
The AC/DC adaptor supplied with the HT-SB30D
●
must not be used with other equipment.
E-3
4" (10 cm)
4" (10 cm)
SOUND BAR HOME THEATER SYSTEM HT-SB30D