General Control; Bass Control - Sharp CD-BH950 Operation Manual

General control

ON/ STANDBY
5
4
3
2
1
Bluetooth
TIMER
ON/ STANDBY
VOL.
CD
CD
TUNER
(BAND)
TAPE
TUNING
AUDIO IN
USB
TUNER
(BAND)
PHONES
AUDIO IN
TAPE
USB
AUDIO IN
USB
■ To turn the power on
The first time the unit is plugged in, the unit will enter the
demonstration mode.
Function Main unit
POWER
Power on/
ON/STANDBY
off
Demo /
____
Bluetooth
Standby
Eco mode
____
Note:
During demonstration or Bluetooth standby mode, NFC
function is activated once your device touches the NFC
detection area.
■ Display brightness control
To dim the display brightness, press the DIMMER button
on the remote control.
(Display is dim).
DIMMER 1
(Display gets dimmer).
DIMMER 2
(Display is bright).
DIMMER OFF
REMOTE
SENSOR
VOL.
OPEN / CLOSE
VOL.
5
4
3
PRESET
2
1
RRMCGA397AWSA
Remote
Operation
control
Press to turn the
power on or to
go to standby
mode.
Press to enter
demonstration
or Bluetooth
standby mode.
Press to enter
low power
consumption
mode.
■ Volume auto fade-in
If you turn off and on the main unit with the volume set to
27 or higher, the volume starts at 16 and fades in to the
last set level.
VOL.
■ Volume control
Turn the volume knob toward VOL. +/– (on main unit) or
press VOL +/– (on remote control) to increase or decrease
the volume.
■ Muting
To mute the volume, press the MUTE ( ) button (remote
control).
Press again to restore the volume.
■ Bass control (X-BASS)
When the power is first turned on, the unit will enter the
extra bass mode which emphasizes the bass frequencies,
and "X-BASS" will appear. To cancel the extra bass mode,
press the X-BASS button.

■ Bass control

1
Press the BASS button to select "BASS".
2
Within 3 seconds, press the VOL (+ or -) button to
adjust the bass.
■ Treble control
1
Press the TREBLE button to select "TREBLE".
2
Within 3 seconds, press the VOL (+ or -) button to
adjust the treble.
■ Auto power on function
When you press any of the following buttons, the unit turns
on.
● Bluetooth, CD, USB, AUDIO IN, TUNER (BAND),
TAPE button (main unit/remote control): Selected
function is activated.
button (main unit): The unit turns on and playback
●
of the last function will start (Bluetooth, CD, USB,
AUDIO IN, TUNER, TAPE).
■ Auto power off function
The main unit will enter the standby mode after 15 minutes
of inactivity during:
AUDIO IN: No detection of input signal or very low sound
audibility.
CD / USB / TAPE: In the stop mode.
Bluetooth: In the pause or stop mode and no incoming
signal from a source device.
E-8