General Control; Volume Control - Sharp GX-BT7 Operation Manual

General control

ON/
STAND-BY
ON/
MUTE ECO MODE STAND-BY
BASS TREBLE VOL
VOL
PAIRING E SOUND
BLUETOOTH AUDIO IN USB
E SOUND
DIMMER
RRMCGA342AWSA
„ To turn the power on
Press the POWER ON/STANDBY button to turn the power on.
When the power is first turned on, the speaker frames move
outward and pneumatic sound will be heard (default setting).
To turn off the pneumatic sound, press and hold the ESOUND
button. The LED lights up and then fades out.
To return to the default setting, press and hold the ESOUND
button again. The LED light will slowly fade in.
After use:
Press the POWER ON/STANDBY button to enter the
power standby mode.
■ LED light brightness control
Press DIMMER button on the remote control to change
the mode.
Dimmer 1
(LED light dim)
Dimmer 2
(LED light gets dimmer.)
Light Off (LED light off during playback only.)
(LED light bright)
Dimmer Off
Note:
LED Light Off mode is only applicable during playback.
■ Volume auto fade-in
If you turn off and on the main unit with the volume set
to almost maximum, the main unit starts with moderate
volume and fades in to the last set level.

■ Volume control

Press VOLUME +/– buttons (on main unit) or VOL +/– (on
remote control) to increase or decrease the volume.
The LED light will blink when the volume reaches maximum
or minimum level.
„ Function
When the FUNCTION button on the main unit is pressed,
the current function will change. Press the FUNCTION
button repeatedly to select the desired function.
Bluetooth
: Pairing indicator lights up.
USB : USB indicator lights up.
: LED lights up at the minimum level.
AUDIO IN
„ Direct key power on function
When you press any of the following buttons, the unit turns on.
 / on the remote control: last selected function activated.
 AUDIO IN on the remote control: audio function activated.
 USB on the remote control: USB function activated.
 BLUETOOTH on the remote control: Bluetooth function
activated
„ Auto power off function
The unit will enter the standby mode if:
Bluetooth:
No connection for 60 seconds.
●
In the pause or stop mode for 20 minutes
●
USB: In the stop mode or no media for 20 minutes
Audio In: No detection of input signal after 20 minutes
Note:
However, if iPod, iPhone or iPad is plugged in, the unit will
begin charging.
„ ESound control
When the power is first turned on, the unit will enter ESound
MODE 1.
To change to a different mode, press the ESOUND button
repeatedly until the desired ESound mode appears.
(Stereo expansion OFF, boost bass sound ON)
MODE 1
(Stereo expansion ON, boost bass sound ON)
MODE 2
(Stereo expansion OFF, boost bass sound OFF)
MODE Off
LED will light up according to the desired ESound mode.
MODE 1
MODE 1
Note:
The ESound mode will be set to MODE Off when BASS/
TREBLE control is adjusted.
„ Bass and treble control
Press BASS or TREBLE +/- button on the remote control to
increase or decrease the bass or treble level respectively.
LED will light up according to the desired Bass or Treble
level.
+ 4
+ 3
+ 2
+ 1
0
- 1
- 2
- 3
- 4
„ Muting
The volume is muted temporarily when pressing the
MUTE button on the remote control. Press again to
restore the volume.
E-7
MODE 2 MODE 2
MODE Off
MODE Off
+ 4
+ 3
+ 2
+ 1
0
- 1
- 2
- 3
- 4