Maintenance Page Definitions - Grandstream Networks GXP1100 User Manual

Layer 3 QoS
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
PC Port Mode
Enabled LLDP

MAINTENANCE PAGE DEFINITIONS

Maintenance -> Web Access
End User Password
Confirm Password
Admin Password
Confirm Password
Maintenance -> Upgrade and Provisioning
Firmware Upgrade and
Provisioning
XML Config File
Password
HTTP/HTTPS User
Name
HTTP/HTTPS Password
Upgrade Via
Firmware Server Path
Config Server Path
Firmware File Prefix
FIRMWARE VERSION 1.0.8.4
server will act as an intermediary to route the packets to the destination.
Defines the Layer 3 QoS parameter. This value is used for IP Precedence,
Diff-Serv or MPLS. The default value is 12.
Assigns the VLAN Tag of the Layer 2 QoS packets. The default value is 0.
Assigns the priority value of the Layer2 QoS packets. The default value is 0.
Configures the PC port mode. When set to "Mirrored", the traffic in the LAN
port will go through PC port as well and packets can be captured by
connecting a PC to the PC port. The default setting is "Enable".
Control the LLDP service.
Allows the administrator to set the password for user-level web GUI access.
This field is case sensitive with a maximum length of 30 characters.
Confirms the end user password field to be the same as above.
Allows users to change the admin password. The password field is purposely
hidden for security purpose. This field is case sensitive with a maximum length
of 30 characters.
Confirms the admin password field to be the same as above.
Specifies how firmware upgrading and provisioning request to be sent: Always
Check for New Firmware, Check New Firmware only when F/W pre/suffix
changes, Always Skip the Firmware Check.
The password for encrypting the XML configuration file using OpenSSL. This
is required for the phone to decrypt the encrypted XML configuration file.
The user name for the HTTP/HTTPS server.
The password for the HTTP/HTTPS server.
Allows users to choose the firmware upgrade method: TFTP, HTTP or HTTPS.
Defines the server path for the firmware server. It could be different from the
configuration server for provisioning.
Defines the server path for provisioning. It could be different from the firmware
server for upgrading.
This field enables user to store different versions of firmware files in one single
GXP1100/GXP1105 USER MANUAL Page 41 of 53