Advertisement
Quick Installation Guide
This guide covers the installation and basic setup procedures for your
AXIS StorPoint HD. If you need more detailed instructions, e.g.
regarding Configuration and Management of the server, please refer
to the AXIS StorPoint HD User's Manual.
Basic Installation
Reset
(black push button)
Power supply connector
Rear view of the standalone version AXIS StorPoint HD
SCSI connector
Power supply connector
Network connectors and push button
Rear view of the tower module AXIS StorPoint HD/T
Before you begin:
•
Standalone version only: Check that the power supply (PS-C,
12V DC) is marked with the correct mains voltage.
•
Make sure that power is not connected to the StorPoint HD
server or any of the Jaz drives. The SCSI bus may be damaged
if you connect or disconnect any units when the power is on.
•
Make sure that your network is ready to accept a new node.
•
Any network configuration should always involve the
Network Administrator.
•
Record the StorPoint HD server serial number. You will need
this number when installing the StorPoint HD server. The
number is found on the underside label of the server.
Connecting Jaz disk drives to the StorPoint HD Server
Up to seven SCSI Jaz disk drives can be serviced by a single Axis
StorPoint HD Server. The drives are connected using the appropriate
SCSI cable, which must be ordered separately
SCSI connector
Network connectors
.
Advertisement
