Samsung AD26B1C13 Service Manual page 22

Step 3 : Reconfirming option set after completion
After pressing
After pressing
Step 4 : Pressing the ON/OFF button (
direction of remote controller for unit, the sound "Ding" or "Diriring" is heard and the first
LED lamp on the left side is flickering at the same time, then the input of option is complet-
ed. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote controller.
Second, Re-insert the battery into the remote controller.
Third, Press ON/OFF key with the direction of remote controller for set.
• Error Mode
1 st If all lamps of indoor unit are flickering, Plug out and plug in again and pressing ON/OFF key to retry.
2 nd If the unit is not working properly or all lamps are continuously flickering after setting the option code, see
if the correct option code is set up for it's model.
! If the first number is
appear.
@ When pressing the
select one of them.
# When pressing the
select one of them.
$ When pressing the
select one of them.
% When pressing the
select one of them.
^ When pressing the
select one of them.
(in case of ex. 000000-1700b7)
selector for the
selector for the
)
When pressing the operation ON/OFF key with the
, it is correct otherwise press
button
button
button
button
button
mode, the display shown as
mode, the display shown as
until
~ appear on the display,
~ appear on the display,
~ appear on the display,
~ appear on the display,
~ appear on the display,
.
.
21