Contents Of Carton - Cub Cadet 190-341-100 Operator's Manual

Contents of Carton

Select a firm level surface that is large enough to accommodate both the snow thrower assembly and the tractor. Remove the upper
crating material, and remove the hardware pack from the shipping crate. Carefully roll the snow thrower assembly rearward so that
it rests on its bottom; then carefully "walk" the snow thrower off the shipping pallet. When repositioning the snow thrower, use care
not to pinch or bind the chute crank support tube and/or lift handle (B and C, Figure 1). Cut the tie strap and remove the packaging
material from the chute crank support tube assembly (B) and position to the left side of the snow thrower assembly. Cut the tie strap
and remove the packaging material from the lift handle assembly (C) and position to the right side of the snow thrower.
Refer to Figures 3-1 and 3-2 to confirm that all parts are present and to acquaint yourself with the part descriptions. Throughout this
manual's instructions, the parts shown in Figures 3-1 and 3-2 will be identified by name, followed by either their callout letter or part
number in parenthesis to aid in assembly and installation.
NOTE: Because different PTO clutch assemblies are used on the various Series 2000 tractor models, two PTO drive belts are provided
with the 341 Snow Thrower. If your tractor has a single cylinder engine, use the 754-0441 (shorter) V-belt. If your tractor has a twin
cylinder engine, use the 754-3075 (longer) V-belt.
C
E
REF. PART #
A N/A
B N/A
C N/A
D 754-0441
E 754-3075
6
B
D
Figure 3-1
DESCRIPTION
Snow Thrower / Discharge Chute Assembly
Chute Crank / Tilt and Support Assembly
Lift Handle / Latch Release Cable Assembly
PTO Belt, Type A; 76.1 Lg- For Single Cylinder Engines
PTO Belt, Type B; 78.3 Lg - For Twin Cylinder Engines
3
A
QUANTITY
1
1
1
1
1