Download Print this page

Wiring Diagram; Specifications - Aiphone JP-DVF-RP10 Instructions

Vandal resistant color video door station with built in hid multiclass se card reader

Advertisement

WIRING DIAGRAM:

JP-DVF-RP10
A1
A2
TESTING & OPERATION:
When power is applied to the card reader, the LED will flash green three (3) times while the
beeper beeps simultaneously. The LED will then turn red. This indicates that the microcontroller is
operating properly.
Present an ID card to the reader (hold card directly in front of reader). The LED will momentarily
turn green while the beeper beeps once, indicating that the card was read successfully.

SPECIFICATIONS:

CARD READER:
Reader type:
Power Source:
Current:
Terminations:
Wiring Distance:
Operating Temp:
Operating Humidity: 0-95% relative humidity
Aiphone Corporation | www.aiphone.com/home | tech@aiphone.com | P: 800.692.0200
RP10
5 ~ 16V DC
75mA (Avg); 200mA (peak)
Color-coded pre-wired pigtail
500'
-31° ~ 150°F / -35° ~ 65°C
non-condensing
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may cause undesired operation.
For proper regulatory compliance, the drain wire should be disconnected at the power
supply end of the cable.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The Reader is intended to be powered from a limited power source output of a
previously certifed power supply
Connect the reader to the host according to the
wiring table below and the host installation guide.
Pigtail
Discription
Yellow
Beeper Input
Orange
Green (GRN) LED Input
Black
Ground (RTN)
Red
+VDC
Drain
Unused
Brown
Red LED Input
Blue
Hold Input
CAMERA:
Camera unit:
Scanning line:
Min. illumination:
Terminations:
Operating Temp:
Wiring Distance:
Dimensions:
JP-4MED
1A1
1A2
2A1
2A2
3A1
+
3A2
-
4A1
4A2
Pigtail
Discription
Red/Grn GPIO1 (RS232-T/RS485-A)
Tan
GPIO2 (RS232-R/RS485-B)
Violet
Open Collector Output
White
Wiegand Data 1 / Clock
Green
Wiegand Data 0 / Data
Pink
GPIO3 (RS485-Z)
Gray
GPIO4 (RS485-Y)
CMOS camera
525 lines
5 Lux at 1'6"
Screw terminals
14° ~ 140°F / -10° ~ 60°C
330' w/ 871802 wire
11-11/16" H x 7" W
JP-DVF-RP10 Instr.
PS-2420UL
+
-
Pg. 2
0715

Advertisement

loading

This manual is also suitable for:

Jp series