Show Mode; Auto - Start Configuration - Martin DMX Controller 2518 User Manual

S
HOW MODE
In show mode, banks execute serially, allowing you to run
some or all banks without additional input. There are 4
sets to choose from: banks 1-10, 11-20, 21-30, and 1-30.
Banks execute 1-6 times before proceeding to the next
bank. After the last bank, the program loops back to the
first bank. The auto, music, and MIDI triggers can be used
to trigger show mode execution.
When the controller is running in show mode, the pro-
gramming and manual execution functions are disabled.
T
O SET SHOW MODE
1. Press and hold both arrow buttons until the
bank display shows one or more horizontal
bars. Use the top controller in tandem mode.
2. Press the up or down arrow button to select
the set of banks to execute. Sets are indi-
cated by bars as shown to right and can be
changed during execution.
3. Press a scene button to select 1-6 loops.
The number is displayed by the scene digit
and can also be changed during execution.
Select a trigger to start program execution.
4.
5. To exit show mode, press and hold both arrow buttons.
A -
UTO START CONFIGURATION
The auto-start feature allows you to select a program to execute on startup.
T
O SAVE AN AUTO
1. Select and execute the startup scene, bank, or show with the desired
trigger options.
2. Press and hold the channel master for several seconds until the
controller resets. When powered up or taken out of standby, execu-
tion resumes at the scene that was executing at this point.
16
-
START CONFIGURATION
1 2 3 4 5 6
Bank 1
1-6 loops
1 2 3 4 5 6
Bank 2
1-6 loops
1 2 3 4 5 6
Bank 10
1-6 loops
Scene Bank
Banks Bar(s)
1-10
11-20
21-30
1-30