Connecting The Product To The Network; For Wired Lan Connection; For Wireless Lan Interface - Epson TM-TM88V-i Technical Reference Manual

Connecting the Product to the Network

For Wired LAN connection

Connect the product to a network by a LAN cable via a hub.
Insert a 10BASE-T/100BASE-TX LAN cable into the LAN connector until it clicks.
 When LAN cables are installed outdoors, make sure devices without proper surge
CAUTION
 Never attempt to connect the customer display cable, drawer kick cable, or a

For Wireless LAN Interface

The optional wireless LAN cable set (OT-W01) enables you to use the product with a wireless LAN
connection.
Be sure not to connect a LAN cable when you use the wireless LAN cable set.
This product cannot be used with the LAN connection and wireless LAN connection at the
same time. When the product is set and installed for both of them, only the LAN connection
works.
Check whether the following items are included.
• Wireless LAN unit
• USB extension cable
• Affixing tape (1 pair, 2 pieces)
• Rubber cover
• Caution label
• User's manual
To connect the wireless LAN unit to the product, you can connect directly or use the USB extension
cable.
If connecting the wireless LAN unit directly causes interference with other cables or bad
communication, use the included USB extension cable.
protection are cushioned by being connected through devices that do have surge
protection. 
Otherwise, the devices can be damaged by lightning.
standard telephone line cable to the LAN connector.
Chapter 2 Setup
2
37