Advertisement
Go to
www.elotouch.com/support
to download user manual.
The stand supports both
upright and lowered
orientations. The stand is
set to the lowered postion
from the factory. Change
the orientation to upright by
removing the green colored
screws from the bottom of
the stand and install them in
the location marked by the
arrows
Tilt the display back to
access the I/O connections
and remove the cable cover.
Connect the power cable to
the DC power jack marked
by the arrow. Then route the
cable through the cable clips
and through the bottom of the
stand.
Serial RS-0232
Ethernet and
USB X2
RS-232 and
USB X2
USB X2
Mic / headphone out
The power button is located at
the bottom as shown.
VGA
+24V PUSB
(X3/X5/X7 models only)
DC Power
Input
Advertisement
