Cycle Selection Chart - GE GSD90 Use And Care Manual

Dial Cycles
(continued)
The RINSE & HOLD cycle is for rinsing
partial loads which will be washed later. Do not
use detergent.
a. Make sure HEATED DRY is off.
b. Be sure the door is unlatched.
c. Slowly turn the Cycle Indicator Dial to
RINSE & HOLD.
d. Latch the door to start the cycle.

Cycle Selection Chart

Water Use
Gallons
Wash Cycles
POTSCRUBBER
NORMAL WASH
LIGHT WASH 7.9
SHORT WASH
RINSE & HOLD 3.0
*Unextended
times. These cycle times will be increased approximately 2 I minutes if Wash Heat Boost option is selected.
Drying Options:
HEATED DRY on. Available on all wash cycles except RINSE& HOLD. Add 35 minutes to wash cycle time.
HEATED DRY off. Drying heater is turned off. Dishes dry naturally.
Time
Minutes
72
43*
12
The PLATE WARMER cycle (on some models)
is for warming clean dishes and serving plates for
the serving of hot foods. The cycle will take
approximately 35 minutes if selected.
a. Load clean plates and dishes to be warmed.
b. Select HEATED DRY on.
c. Be sure the door is unlatched.
d. Slowly turn the Cycle Indicator dial to
PLATE WARMER.
e. Latch the door to start the cycle.
Cycle Sequence
5