Panasonic ECONAVI NA-FS95G3WAU Operating Instructions Manual page 25

Problem
●
●
●
Doesn't dry well.
●
●
●
Synthetic powdered
detergent does not
dissolve completely.
●
●
There is hardly any
●
foam.
●
●
There is too much
foam.
●
Power failure/Circuit
breaker has tripped.
●
Water supply is
disrupted.
●
The washing machine
keeps beeping and the
water is being drained.
 Wrap warm towels around the joints of the water supply hoses.
 Disconnect the water supply hoses, and soak them in warm
The water supply hoses
are frozen.
 Add 2 L to 3 L of warm water (50°C or lower) to the tub.
Check points
Did you load clothes made of materials other than synthetic
fibres or do the clothes weigh 3 kg or more?
Did you wring the clothes by hand? If so, the water is not
removed enough.
Is the drying time set too short?
Is the air inlet clogged?
→ Remove the lint and dust on the air inlet.
Since the "Air Dry" cycle is timer-controlled, it terminates
regardless of the dryness.
→ If the clothes are still wet, run an additional "Air Dry" cycle.
Did you add the synthetic powdered detergent directly to the
tub?
→ Add it to the powdered detergent inlet.
Did you add the synthetic powdered detergent to the powdered
detergent inlet?
Did you add too little detergent?
Did you load too many clothes or are they soiled heavily?
Depending on the type (low foam detergent, etc.) or amount of
your detergent or the hardness, temperature, and amount of
water, there may be hardly any foam.
Depending on the type (neutral liquid detergent, etc.) or
amount of your detergent or the hardness, temperature, and
amount of water, there may be too much foam.
→ Add less detergent.
Even if a power failure occurs, the washing machine restarts
automatically when the power supply is restored. To
discontinue the use, press the [Power Off] button.
When the water supply is restored, it may be impure at first.
→ Disconnect the water supply hoses and drain away the
impure water through the taps.
Is the Child Lock set?
→ To stop the water from draining, disconnect the power plug,
wait for 5 seconds, and reconnect it.
water (50°C or lower).
Page
19
–
19
22
19
21
21
20
–
–
20
–
23
5
–
25