Press The [Water Level - Panasonic ECONAVI NA-FS95G3WAU Operating Instructions Manual

Customise the settings
You can customise the water temperature
setting for the wash stage of a cycle, the wash/
rinse/spin settings and the water level setting.
■ Set the water temperature for main
wash fill
Water temperature
Hot: Approx. 40 °C
Warm: Approx. 30 °C
Cold: Approx. 20 °C
After performing Step 2 on page 10, press
the [Temp Setting] button repeatedly until
the lamp of the desired water temperature
lights up.
■
Set the wash/rinse/spin settings
After performing Step 2 on page 10, press the
[Wash], [Rinse] or [Spin] button repeatedly until
the lamps of the desired cycles light up.
●
To change the wash/rinse/spin settings
after a cycle has started:

Press the [Pause] button, and change
the settings.

Press the [Start] button to restart.
■
Set the water level
After performing Step 3 on page 10, press
the [Water Level] button repeatedly until the
desired water level indicator lights up.
Note
●
You cannot change the water temperature
setting once a cycle starts.
●
Some settings may not be available
depending on the cycle. (P.12)
Timer Delay function
You can select the finish time of a cycle
2–24 hours from the current time.
After performing Step 2 on page 10, press
the [Timer Delay] button and select the
finish time (hours).
●
The time is shown in the display area.
●
The time increases by an hour each time you
press the button.
■
Check the set details
Press the [Timer Delay] button when the
timer is set.
●
The cycle, wash/rinse/spin settings, water
temperature setting, water level and finish
time will be displayed.
■
Cancel or change the finish time
Press the [Power Off] button to turn off the
washing machine, and repeat the operations
from Step 1 on page 10.
Note
●
All indicators, lamps and displays except for
the "Reserve" information on the display
area and the ECONAVI display go off
2 minutes after pressing the [Start] button.
●
Do not use soap powder.
●
The finish time can exceed the programmed
time due to the water feeding and draining
condition.
●
This function is not available depending on
the cycle. (P.12)
11