Advertisement
IV
IR Configuration on Camera
To configure the IR-related settings in camera firmware:
1. Open a browser management session according to your QIG (Quick Installation Guide).
2. On the main page, enter Configuration > Advanced mode > Media > Image (General
settings) > click on a tab at the lower screen to open Day/Night settings.
3. Select the checkbox in front of "Turn on external IR illuminator in night mode." Click
Save to preserve your setting.
Once the configuration is done, the network camera will automatically turn on the
illuminator when its light sensor detects low-light conditions, e.g., when the night falls.
NOTE:
If the external IR illuminator setting is enabled, all DO-related settings you previously
configured in the Event configuration will be erased.
Since only one pair of digital output lines are available, once the IR illuminator is enabled,
the other Digital output options will be disabled.
8
Advertisement
