Advertisement
Waterproof Connector
Assembling Steps
1. Disassemble the components of the
waterproof connector into parts (A) ~ (F)
as shown above.
2. Place the screw nut (E) on the Power and
GPIO opening.
3. Feed the power cables through the
waterproof connector (F --> E --> D -->
B --> A) as the illustration shows. Then
connect the power cables to the power
source. Note: There are 8 holes on the
seal (D), and the widest holes with a crack
on the side are specific for power cables.
4. If you have external devices such as
sensors and alarms, feed the cables
through the waterproof connector (F
Sealing Nut (A)
Housing (B)
Seals (C)
Seal (D)
Screw Nut (E)
Hex Nut (F)
--> E --> D --> B --> A) as previously
described. Refer to the pin definition to
connect them to the general I/O terminal
block. Note: The recommended cable
gauge is 2.0 ~ 2.8 mm.
5. Push the seal (D) into the housing (B).
6. Insert the seals (C) into unused holes on
the seal (D) to avoid moisture.
7. Secure the sealing nut (A) tightly and
hex nut (F) from the bottom of the
camera.
7
(A)
(B)
(D)
(E)
(F)
Advertisement
