Location Of Parts And Controls; Front Side - Honeywell Q7055A Installation Instructions Manual

BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN

2 Location of Parts and Controls

The numbering for the parts and controls in this
section refers to the pictures on the rear side of the
title page. In order to have a reference between the
numbering here and the device pictures, it is
possible to fold this page out.
2.1

Front Side

Differences between the various BNA types are
explicitly noted in the corresponding element
description.
1
2
3
8
Reset
Hardware reset button. Located directly behind
the small hole in the front panel. To reach this
button, a pointed object like a sharp pen or an
unfolded paper clip is necessary. Pressing this
button resets the BNA device immediately. This
operation is similar to "power on" with the
BNA device.
Mode
Mode switch button. This button is needed to
change the bootloader modes. For a detailed
description about BNA operation modes, please
refer to chapter 6.2 Operating Modes on Page 25.
LAN
Local Area Network (LAN) activity display.
EN1B-0198GE51 R1004B