6.5.6
ver - Show installed software
The command ver outputs a list of all installed
software components on the current BNA device.
6.5.7
run - Execute installed software
The command run starts a previously-installed
application firmware.
If no application firmware could be found, then the
information No executable found is printed
out. In this case, use load to download an
application firmware.
6.5.8
um - User management
The user management command um allows the
definition of users, different access rights per user
and user individual password settings.
User definitions are necessary to provide a secure
device on an open TCP/IP network. Furthermore it
may not be desired that every user will be allowed
to do everything with a BNA device.
These user accounts are required only for set-up,
configuration and diagnostic applications if avail-
able. The communication protocols allowing the
communication between BNA and its building
management system are protected at the protocol
level depending on the type of application firm-
ware.
EN1B-0198GE51 R1004B
BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN
37