Load - Load Executable; Ping - Ping - Honeywell Q7055A Installation Instructions Manual

BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN
6.5.4

load - Load executable

The command load is a direct command which
immediately starts downloading the application
firmware image into the BNA based on the
download configuration defined by the command dc.
After loading the image into local memory, the
BNA Bootloader starts copying the image into the
local Flash memory where it resides until updated
the next time.
load accepts optional command-line parameters.
Accepted command-line parameters are FTP-Server
IP-Address and/or filename. Command-line para-
meters supersede the current download con-
figuration for these elements. Command-line para-
meters in the load command scope can be used to
use an alternative FTP-Server for downloading or
to download another application firmware image
into the BNA device.
If load fails, then it needs to be checked whether the
correct download configuration has been defined.
In this case, the command dc test becomes useful.
6.5.5

ping - ping

Sends an ICMP Ping through TCP/IP to the FTP-
Server defined in the download configuration or to
the machine addressed by the IP-Address in the
optional command-line parameter.
This command can be used to check whether the
network connection is working properly.
36 EN1B-0198GE51 R1004B