Table of Contents
Advertisement
4
Supported Software
Installing the AHCI Driver During Windows XP Installation
The AHCI driver must be installed during the Windows
installation using the F6 installation method. This is required in order
to install the operating system onto a hard drive when in AHCI
mode.
1.
2.
3.
4.
5.
You have successfully installed the driver. However you must continue
installing the OS. Leave the floppy disk in the floppy drive until the
system reboots itself because Windows setup will need to copy the
files again from the floppy disk to the Windows installation folders.
After Windows setup has copied these files again, remove the floppy
diskette so that Windows setup can reboot as needed.
90
Start Windows Setup by booting from the installation CD.
Press <F6> when prompted in the status line with the 'Press
F6 if you need to install a third party driver' message.
Press <S> to "Specify Additional Device".
At this point you will be prompted to insert a floppy disk
containing the AHCI driver. Insert the provided floppy diskette.
Locate for the drive where you inserted the diskette then select
AHCI controller that corresponds to your BIOS setup. Press
<Enter> to confirm.
®
XP
Advertisement
Table of Contents
