Table of Contents
Advertisement
The system board supports USB 2.0 and USB 1.1
USB
ports. USB 1.1 supports 12Mb/second bandwidth
while USB 2.0 suppor ts 480Mb/second bandwidth providing a
marked improvement in device transfer speeds between your com-
puter and a wide range of simultaneously accessible external Plug
and Play peripherals.
wake-on-ring
wake-up/power-on to respond to calls coming from an external mo-
dem or respond to calls from a modem PCI card that uses the PCI
PME (Power Management Event) signal to remotely wake up the
PC.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
wake-on-lan
It is supported via the onboard LAN port or via a PCI LAN card
that uses the PCI PME (Power Management Event) signal. However,
if your system is in the Suspend mode, you can power-on the system
only through an IRQ or DMA interrupt.
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
wake-on-PCI-EVENT
Management Event) signal. However, if your system is in the Suspend
mode, you can power-on the system only through an IRQ or DMA
interrupt.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
This feature allows the system that is in the
Suspend mode or Soft Power Off mode to
This feature allows the network to remotely
wake up a Soft Power Down (Soft-Off) PC.
This feature is supported via a PCI
card that uses the PCI PME (Power
Introduction
1
11
Advertisement
Table of Contents
