Table of Contents
Advertisement
3
BIOS Setup
Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your
system.
Delay 4 Sec. Regardless of whether the Power Management func-
Instant-Off
Wake-Up By PCI Event
Enabled
Disabled
Power On By Ring
When this field is set to Enabled, the system will power-on to respond
to calls coming from a modem.
USB KB Wake-Up From S3
This field, when enabled, allows you to use a USB keyboard to wake
up a system that is in the S3 (STR - Suspend To RAM) state. This
can be configured only if the "ACPI Suspend Type" field is set to
"S3(STR)".
62
tion is enabled or disabled, if the power button is
pushed and released in less than 4 sec, the system
enters the Suspend mode. The purpose of this func-
tion is to prevent the system from powering off in
case you accidentally "hit" or pushed the power but-
ton. Push and release again in less than 4 sec to
restore. Pushing the power button for more than 4
seconds will power off the system.
Pressing and then releasing the power button at
once will immediately power off your system.
This field should be set to Enabled only if your PCI
card such as LAN card or modem card uses the PCI
PME (Power Management Event) signal to remotely
wake up the system.
card will cause the system to wake up.
card's documentation for more information.
The system will not wake up despite access to the PCI
card.
Access to the LAN card or PCI
Refer to the
Advertisement
Table of Contents
