CLEARANCE BETWEEN FEED DOG AND NEEDLE PLATE
1. To adjust a clearance between feed dog and needle plate, set SL dial at "5"
and DF dial at "1". Turn the handwheel towards you until feed dog moves to far
rear position. Loosen screw "k" and move feed bar "m" back and forth to
obtain a clearance " F " of
2. Turn the handwheel towards you until feed dog moves to far front position. Check
and make sure if a clearance between feed dog and needle plate is 0.7 mm.
(Fig. 2)
m
ANNEX
0.3 to 0.5
mm. (Fig. 1) Fasten screw "k".
0.3~0.5mm
F
Fig.1
0.7
Fig.2
k
3mm