Chrysler 2015 300 SRT Operating Information Manual page 165

grid lines will be displayed for up to 10 seconds
after shifting out of "REVERSE" unless the
forward vehicle speed exceeds
(12 km/h), the transmission is shifted into
"PARK" or the ignition is switched to the OFF
position. To set the ParkView® Backup Camera
Delay press the "Controls" button on the touch-
screen, the "settings" button on the touch-
screen, then the "Safety & Driving Assistance"
button on the touchscreen. Press the "Parkview
Backup Camera Delay" button on the touch-
screen to turn the ParkView® Delay ON or OFF.
• Rain Sensing Auto Wipers
When this feature is selected, the system will
automatically activate the windshield wipers if it
senses moisture on the windshield. To make
your selection, press the "Rain Sensing Auto
Wipers" button on the touchscreen, until a
check-mark appears next to setting, indicating
that the setting had been selected. Press the
back arrow button on the touchscreen to return
to the previous menu.
162
• Hill Start Assist — If Equipped
When this feature is selected, the Hill Start
8 mph
Assist (HSA) system is active. Refer to "Elec-
tronic Brake Control System" in "Starting And
Operating" for system function and operating
information. To make your selection, press the
"Hill Start Assist" button on the touchscreen,
until a check-mark appears next to setting,
indicating that the setting had been selected.
Press the back arrow button on the touchscreen
to return to the previous menu.
Lights
After pressing the "Lights" button on the touch-
screen the following settings will be available.
• Headlight Off Delay
When this feature is selected, it allows adjust-
ment of the amount of time the headlights
remain on after the engine is shut off. To change
the Headlights Off Delay setting, press the "+"
or "-" button on the touchscreen to select your
desired time interval, and choose either 0 sec,
30 sec, 60 sec or 90 seconds. Press the back
arrow button on the touchscreen to return to the
previous menu, or push the back button on the
faceplate.
• Headlight Illumination On Approach
When this feature is selected, the headlights will
activate and remain on for 0, 30, 60, or 90
seconds when the doors are unlocked with the
Remote Keyless Entry (RKE) transmitter. To
change the Illuminated Approach status, press
the "+" or "-" button on the touchscreen to select
your desired time interval. Press the back arrow
button on the touchscreen to return to the
previous menu, or push the back button on the
faceplate.
• Headlights With Wipers — If Equipped
When this feature is selected, and the headlight
switch is in the AUTO position, the headlights
will turn on approximately 10 seconds after the
wipers are turned on. The headlights will also
turn off when the wipers are turned off if they
were turned on by this feature. To make your
selection, press the "Headlights With Wipers"
button on the touchscreen, until a check-mark
appears next to setting, indicating that the set-
ting has been selected. Press the back arrow
button on the touchscreen to return to the
previous menu, or push the back button on the
faceplate.