Memory Position Recall; Easy Entry/Exit Seat - Chrysler 2015 300 SRT Operating Information Manual

(2) accordingly. "Memory Profile Set" (1 or 2)
will display in the instrument cluster.
4. Push and release the LOCK button on the
RKE transmitter within 10 seconds.
NOTE:
Your RKE transmitters can be unlinked to
your memory settings by pushing the SET
(S) button, and within 10 seconds, followed
by pushing the UNLOCK button on the RKE
transmitter.

Memory Position Recall

NOTE:
The vehicle must be in PARK to recall
memory positions. If a recall is attempted
when the vehicle is not in PARK, a message
will display in the DID (if equipped).
To recall the memory settings for driver one,
push MEMORY button number (1) on the driv-
er's door or the UNLOCK button on the RKE
transmitter linked to memory position 1.
To recall the memory setting for driver two, push
MEMORY button number (2) on the driver's
door or the UNLOCK button on the RKE trans-
mitter linked to memory position 2.
A recall can be cancelled by pushing any of the
MEMORY buttons (S, 1, or 2) on the driver's
door during a recall. When a recall is cancelled,
the driver seat, adjustable pedals (if equipped),
and power tilt and telescopic steering column (if
equipped) stop moving. A delay of one second
will occur before another recall can be selected.

Easy Entry/Exit Seat

This feature provides automatic driver seat po-
sitioning to enhance driver mobility when enter-
ing and exiting the vehicle.
The distance the driver seat moves depends on
where you have the driver seat positioned when
you cycle the vehicles ignition to the OFF
position.
• When you cycle the vehicles ignition to the
OFF position, the driver seat will move about
2.4 in (60 mm) rearward if the driver seat
position is greater than or equal to 2.7 in
(67.7 mm) forward of the rear stop. The seat
will return to its previously set position when
you cycle the vehicles ignition to the ACC or
RUN position.
• The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than 0.9
in (22.7 mm) forward of the rear stop. At this
position, there is no benefit to the driver by
moving the seat for Easy Exit or Easy Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled
when the vehicle is delivered from the fac-
tory. The Easy Entry/Exit feature is enabled
(or later disabled) through the program-
mable features in the Uconnect® system.
Refer to "Uconnect® Settings/Customer
Programmable Features" in "Understanding
Your Instrument Panel" for further informa-
tion.
81