Indholdsfortegnelse Vigtige instruktioner Udpakning og opstilling El-tilslutning Hvor er hvad Opstart Termostaten Afrimning Flytning af hylder Vedligeholdelse Service Bortskaffelse Elektrisk skema Contents Important safety instructions Unpacking and installation Electrical connection Where is the parts Start-up of the cabinet Thermostat Internal light Defrosting Moving the shelves Maintenance and cleaning...
Vigtige informationer 1. For at få det fulde udbytte af køleren, bør De læse denne brugsvejledning igennem. 2. Det er brugers ansvar at anvende køleren i henhold til instruktionerne. 3. Kontakt omgående forhandleren, såfremt der opstår fejl ved køleren. 4. Køleren bør anbringes i et tørt og tilstrækkeligt ventileret rum. 5.
Hvor er hvad 1. LED lys 5. Justerbare fødder 2. Ventilator 6. Termostat 3. Tætningsliste 7. Kompressor 4. Kondensator 8. Genfordampnings bakke Opstart Inden køleren tages i brug, anbefales det at rengøre de indvendige overflader, se afsnit om vedligeholdelse. Vigtigt ! Hvis køleren har ligget ned under transport, vent 2 timer før opstart.
Køleren har indbygget LED lys, der er tænder automatisk når døren åbnes. Udskiftning af LED-stribe foretages ved at fjerne afdækningen og frakoble LED-striben i stikket, det udskiftet men en tilsvarende LED-stribe (12 VDC). Afrimning Skabet afrimer automatisk. Tøvand ledes ud til genfordampning i en beholder, der er placeret i kompressorrum.
Important safety instructions 1. To obtain full use of the cabinet, we recommend reading this instruction manual. 2. It is the user’s responsibility to operate the appliance in accordance with the instructions given. 3. Contact your dealer immediately in case of any malfunctions. 4.
Where is the parts 1. Internal LED light 5. Adjustable feet 2. Evaporator fan 6. Thermostat 3. Gasket 7. Compressor 4. Condenser 8. Drip tray Start-up of the cabinet Before use, we recommend that the cabinet is cleaned, see the section on maintenance and cleaning. Important ! If the cabinet has been vertically placed during transport, please wait 2 hours before starting up the cabinet.
Light The internal light is a LED type, witch automatically switches on when the door is opened. Replacing the LED-strip is done by removing the lamp cover and disconnect the wires. Replace with similar type of LED-strip (12 VDC). Defrosting The cabinet defrosts automatically.