Aps Protection Switching Byte Failure; Aps Channel Mismatch Failure; Aps Mode Mismatch Failure - Alcatel-Lucent 7750 SR OS Interface Configuration Manual

Port Features

APS Protection Switching Byte Failure

An APS Protection Switching Byte (APS-PSB) failure indicates that the received K1 byte is either
invalid or inconsistent. An invalid code defect occurs if the same K1 value is received for 3
consecutive frames (depending on the interface type (framer) used, the 7750 may not be able to
strictly enforce the 3 frame check per GR-253 and G.783/G.841) and it is either an unused code or
irrelevant for the specific switching operation. An inconsistent APS byte defect occurs when no
three consecutive received K1 bytes of the last 12 frames are the same.
If the failure detected persists for 2.5 seconds, a Protection Switching Byte alarm is raised. When
the failure is absent for 10 seconds, the alarm is cleared. This alarm can only be raised by the
active port operating in bi-directional mode.

APS Channel Mismatch Failure

An APS channel mismatch failure (APS-CM) identifies that there is a channel mismatch between
the transmitted K1 and the received K2 bytes. A defect is declared when the received K2 channel
number differs from the transmitted K1 channel number for more than 50 ms after three identical
K1 bytes are sent. The monitoring for this condition is continuous, not just when the transmitted
value of K1 changes.
If the failure detected persists for 2.5 seconds, a channel mismatch failure alarm is raised. When
the failure is absent for 10 seconds, the alarm is cleared. This alarm can only be raised by the
active port operating in a bi-directional mode.

APS Mode Mismatch Failure

An APS mode mismatch failure (APS-MM) can occur for two reasons. The first is if the received
K2 byte indicates that 1:N protection switching is being used by the far-end of the OC-N line,
while the near end uses 1+1 protection switching. The second is if the received K2 byte indicates
that uni-directional mode is being used by the far-end while the near end uses bi-directional mode.
This defect is detected within 100 ms of receiving a K2 byte that indicates either of these
conditions.
If the failure detected persists for 2.5 seconds, a mode mismatch failure alarm is raised. However,
it continues to monitor the received K2 byte, and should it ever indicate that the far-end has
switched to a bi-directional mode the mode mismatch failure clearing process starts.
When the failure is absent for 10 seconds, the alarm is cleared, and the configured mode of 1+1
bidirectional is used.
Page 50 7750 SR OS Interface Configuration Guide