Sharp LC-37AD1E Service Manual page 39

(1) Adjusting method using RS-232C
• Get a personal computer with a COM port (RS-232C) equipped with WINDOWS 95/98/me/2000/xp and
a RS-232C crossing cable
• Start up the set with the RS-232C cable connected.
• Start up the terminal software.
(Freeware products available on the Internet can be used.)
• Make setting as shown below.
Baud rate : 9600
Data : 8 bits
Parity : None
Stop : 1 bit
Flow control : None
• If the above setting is made correctly, pressing the "OK" key on the PC will make "ERR" appear on the
terminal software.
• In this state, entering a command shown in the table bellow and pressing the "OK" key will allow you to
make an adjustment.
If "OK" is displayed on the terminal software after the "OK" key is pressed, the command has been
entered successfully.
If "ERR" is displayed, enter the command again.
RS232C command table
Command
Function
MSET1001 Used to start the background adjustment.
MOFR~~~~ Used to adjust the value of R OFFSET.
MOFG~~~~ Used to adjust the value of G OFFSET.
MOFB~~~~ Used to adjust the value of B OFFSET.
MGAR~~~~ Used to adjust the value of R GAMMA.
MGAG~~~~
Used to adjust the value of G GAMMA.
MGAB~~~~ Used to adjust the value of B GAMMA.
MINF0000 Used to display the R GAMMA table.
MINF0001 Used to display the B GAMMA table.
MINF0002 Used to display the G GAMMA table.
Remarks
The adjustment ends with a numeric value other than 1001.
Range: 0000 to 0512 (Initial value: 0255)
Range: 0000 to 0512 (Initial value: 0255)
Range: 0000 to 0512 (Initial value: 0255)
Range: 0000 to 0255 (Initial value: 0100)
Range: 0000 to 0255 (Initial value: 0100)
Range: 0000 to 0255 (Initial value: 0100)
39
LC-37AD1E