Table of Contents
Advertisement
TROUBLESHOOTING
• The entire unit shuts off during use, switch is in the "on" position
-
The unit has overheated from exceeding the duty cycle and the internal thermal protection circuitry has been activated. Turn the main power switch off, wait several
minutes to allow cooling then turn power switch back on. The unit is ready for service.
• The power switch is on, the indicator light is illuminated, the fan is running however when the Torch activation button
is depressed, there is no sound from the Pilot Arc Igniter and there is no air flow
-
Check all connections. A loose connection will prevent Torch activation.
-
Check for damaged lines, Torch or Torch Tip.
-
Make sure there is sufficient air flow & pressure. (60 PSI)
• The power switch is on, the indicator light is illuminated, the fan is running however when the Torch activation button is
depressed, there is airflow through the torch but no sound from the Pilot Arc Igniter:
-
Check all connections. A loose connection will prevent Torch activation.
-
Check for damaged lines, Torch or Torch Tip.
-
Inspect the Torch Tip for damage, excessive molten material build-up or excessive burning. Replace if necessary.
-
Lower Air Pressure to 60 PSI or below
• The power switch is on, the indicator light is illuminated, the fan is running and when the Torch activation button is
depressed, there is airflow through the torch, the Pilot Arc Igniter is activating however a plasma arc cannot be started
-
Check all connections. A loose connection will prevent Torch activation.
-
Check for damaged lines, Torch or Torch Tip.
-
Inspect the Torch Tip for damage, excessive molten material build-up or excessive burning. Replace if necessary.
-
Input voltage is too low or too high (below 110V or above 240V).
-
Air pressure is too low or too high. Adjust to 60 PSI.
• The Pilot Arc is sputtering
-
Lower air pressure to 60 PSI or below.
-
Replace the nozzle and electrode in the torch.
REPLACEMENT ITEMS:
#14343
Plasma Cutter Torch Assembly, CB70
#14344
Electrode (10pk), Versa Cut 60
#12814
Nozzle (10pk), Versa Cut 40/60
#14557
External Nozzle (2pk), Versa Cut 60
#13788
Air Diffuser (2pk), Versa Cut 40/60
#14555
Nozzle Guide (10pk), Versa Cut 60
ACCESSORIES:
#13689
Plasma Cutting Guide
#13948
Plasma Cutting Glasses
#12590
Welding Gloves - Large
© Copyright 2014 Easthill Group, Inc.
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com
PDF version of this manual is available online >> eastwood.com/14099manual
The Eastwood Company
US and Canada: 800.345.1178
263 Shoemaker Road, Pottstown, PA 19464, USA
Outside US: 610.718.8335
Fax: 610.323.6268
eastwood.com
Instruction part #14099Q
Rev. 12/14
Advertisement
Table of Contents
