Table of Contents
Advertisement
SAFETY INFORMATION
READ INSTRUCTIONS!
•
Thoroughly read and understand this instruction manual before using the Plasma Cutter.
•
Keep this instruction booklet
ELECTRIC SHOCK CAN KILL!
•
Improper use of a Plasma Cutter can cause electric shock, injury and death! Read all precautions described
in this manual to reduce the possibility of electric shock.
•
Do not touch any electrical components that may be live.
•
Separate yourself from the Plasma Cutter circuit by using insulating mats to prevent contact from the work surface.
•
The Plasma Cutter power switch is to be in the OFF position and the power supply is to be disconnected when performing any
maintenance or consumable changes.
•
Always wear dry, protective clothing and leather cutting gloves and insulated footwear.
•
Always operate the Plasma Cutter in a clean, dry, well ventilated area. Do not operate the Plasma Cutter in humid, wet,
rainy or poorly ventilated areas.
•
Be sure that the work piece is properly supported and grounded prior to beginning an electric Plasma Cutter operation.
•
The electrode and work (or ground) circuits are electrically "hot" when the welder is on. Do not touch these "hot" parts with your
bare skin or wet clothing.
•
Disconnect from power supply before assembly, disassembly or maintenance of the torch or contact tip.
•
Always attach the ground clamp to the piece to be welded and as close to the weld area as possible. This will give the least
resistance and best cut.
FUMES AND CUTTING GASES CAN BE DANGEROUS!
•
Do not breathe fumes that are produced by the cutting operation. These fumes are dangerous. Keep your head and face out of
cutting fumes. Do not breathe the fumes.
•
Always work in a properly ventilated area. Wearing an OSHA-approved respirator when cutting is recommended!
•
Never cut coated materials including but not limited to: cadmium plated, galvanized, lead based paints.
•
Refer to the MSDS (Material Safety Data Sheet) for any consumables or materials used during cutting for additional safety instructions.
CUTTING SPARKS CAN CAUSE FIRE OR EXPLOSION!
•
Do not operate Plasma Cutter in areas where fl ammable or explosive vapors are present.
•
Always keep a fi re extinguisher nearby while cutting.
•
Use cutting blankets to protect painted surfaces, dash boards, engines, etc.
•
Ensure power supply has properly rated wiring to handle power usage.
•
Do not use on or near combustible surfaces.
•
Remove all fl ammable items within 35 feet of the cutting area.
To order parts and supplies: 800.345.1178 >> eastwood.com
3
Advertisement
Table of Contents
