Checking, Disassembling And Servicing; Checking And Adjusting; Disassembling And Assembling; Parking Brake - Kubota G2160 Workshop Manual

G2160, WSM

4. CHECKING, DISASSEMBLING AND SERVICING

[1] CHECKING AND ADJUSTING

[2] DISASSEMBLING AND ASSEMBLING

(1) Parking Brake

Brake Pedal Play
1. Keep the brake return spring (1) off position.
2. Keep the brake pedal in return position.
3. Gently press the tip of the transaxle's brake actuating arm (5)
toward the pedal.
4. Set the brake spring (4) so as to be −1.0 to 0.0 mm (−0.04 to 0.00
in.) shorter than free length.
5. If the measurement is not within the factory specifications, adjust
with the nut (3).
6. Tighten up the lock nut (2).
Clearance between
brake spring and plain Factory spec.
washer (L)
(Reference)
• Brake Pedal Play : 15 to 25 mm (0.59 to 0.98 in.)
(1) Brake Return Spring
(2) Lock Nut
(3) Nut
(4) Brake Spring
(5) Transaxle's Brake Actuating Arm
Dismount Mower
1. See to "MOWER" section.
Battery and Bonnet
1. Turn the main switch off.
2. Remove the radiator screen (2)
3. Disconnect the negative cable (1) from the battery.
4. Disconnect the 1P connectors (4) from the head light (3).
5. Remove the wiring (5) from the bonnet.
6. Remove the bonnet stay mounting screws (7), and remove the
bonnet with the bonnet bracket (6) from the frame.
(1) Negative Cable
(2) Radiator Screen
(3) Head Light
(4) 1P Connectors
Wiring
1. Remove the indicator lamps (4).
2. Disconnect 1P connector (3) from the hour meter.
3. Disconnect 1P connector (1) from the light switch.
4. Disconnect 4P connector (2) from the main switch.
5. Disconnect P connector (5) from the KRA system switch.
(1) 1P Connector
(2) 4P Connector
(3) 1P Connector
3-S2
−1.0 to 0.0 mm
−0.04 to 0.00 in.
(A) Forward
(L) Clearance between brake spring
and plane washer
W1010868
W1011157
(5) Wiring
(6) Bonnet Bracket
(7) Bonnet Stay Mounting Screws
W1011210
(4) Indicator Lamps
(5) P connector
W1011427
KiSC issued 11, 2006 A
BRAKE