Connecting The Remote Control Jacks; Connecting Other Equipment - Marantz SR6003 User Manual

ENGLISH

CONNECTING THE REMOTE CONTROL JACKS

INPUT 1( ( TV INPUT 1 TV) )
DVD( ( 2 2 ) ) VD VCR IN VCR IN( ( 3 3 ) ) VCR OUT VCR OUT DSS( ( 4 4 ) ) DSS MONITOR OUT MONITOR OUT Y Y C C / / P P C C / / P P Y Y C C / / P P
B B B B R R R R B B
INPUT 2( ( DVD DVD) )
DIGITAL DIGITAL FLASHER IN FLASHER IN REMOTE CONT. REMOTE CONT. REMOTE CONT. REMOTE CONT. INPUT 2 OUTPUT 1 OUTPUT 1
DIGITAL IN DIGITAL IN
REC/ZONE B REC/ZONE B
SIRIUS SIRIUS
IN IN IN IN
5 5
2 2 3 3
OUT OUT DC OUT DC OUT OUT OUT OUT OUT
AC OUTLETS AC OUTLETS
120V 120V 60Hz 60Hz
L L
UNSWITCHED UNSWITCHED
1.25A 150W 1.25A 150W
SURROUND BACK OUND BACK SWITCHED SWITCHED
AC IN AC IN
SPEAKER C/ EAKER C/
1.25A 150W 1.25A 150W
ZONE SPEAKER A SPEAKER A
1
CD recorder
REMOTE REMOTE
CONTROL CONTROL
IN IN
OUT OUT
EXTERNAL INTERNAL
q
You can control other Marantz products through this
unit with the remote controller by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote controller
is received by the remote sensor on this unit. Then
the signal is sent to the connected device through
this terminal. Therefore you need to aim the remote
control only at the unit. Also, if a Marantz power
amplifi er (some models excluded) is connected to
one of these terminals, the power amplifi er's, power
switch is synchronized with this unit's power switch.
Set the REMOTE CONTROL SWITCH on the back of
other units (not the SR6003) to "EXT." (EXTERNAL)
to use this feature.
22
INPUT 3 INPUT 3( ( VCR VCR) )
COMPONENT COMPONENT
VIDEO VIDEO
2
C C / / P P Y Y C C / / P P C C P P / /
B B R R R R B B B B R R R R
OUTPUT 2 OUTPUT 2
RC OUT
MODEL NO. SR6003 MODEL NO. SR6003
DVD player
REMOTE
CONTROL
IN
OUT
EXTERNAL INTERNAL
w
Whenever external infrared sensors or similar devices
are connected to RC-5 IN of the unit, be sure to
always disable operation of the infrared sensor on the
unit by using the following procedure.
1.
Hold down the SURROUND MODE button
and the MENU button on the front panel at the
same time for fi ve seconds.
2.
The setting "IR=ENABLE" is shown on the FL
DISPLAY.
3.
Press the CURSOR buttons (1, 2) to change
this to "IR=DISABLE".
4.
Press the ENTER button. Once this setting
is made, the infrared sensor on the unit is
disabled.
Note:
• Be sure to set to "IR=ENABLE" when external
infrared sensors or similar devices are not connected.
Otherwise, the unit will be unable to receive remote
control commands.
5.
To restore the original setting, perform steps 1
to 4 to set to "IR=ENABLE".

CONNECTING OTHER EQUIPMENT

a
OPTION
FM FM
Ω ) )
( ( 75 75Ω GND GND AM AM
INPUT 1( ( TV INPUT 1 TV) ) INPUT 2 INPUT 2( ( DVD
L L SL SL C C
L L
R R
R R SR SR SW SW
( ( AUX 2 AUX 2) ) 7.1CH INPUT 7.1CH INPUT
RS-232C RS-232C RS-232C RS-232C
SPEAKER C SPEAKER C
OFF OFF ON ON
L L SL SL C C
CD player
R R SR SR SW SW
PRE OUT PRE OUT
EXTERNAL INTERNAL
a RS-232C
Connect an external control device or other device for
servicing. (Use a straight cable for the connection.)
s DC OUT (DC TRIGGER)
External devices can be controlled from the unit
by connecting them to the DC OUT terminal (12 V
44mA max).
d FLASHER IN
This unit can be controlled by connecting a control
box or other control device to this unit.
VIDEO VIDEO
ANTENNA ANTENNA
DVD) ) INPUT 3( ( VCR INPUT 3 VCR) ) OUTPUT 1 OUTPUT 1 OUTPUT 2 OUTPUT 2
S-VIDEO S-VIDEO
AUDIO AUDIO
SBL SBL
ZONE A ZONE A TV TV DVD DVD VCR VCR DSS DSS TAPE TAPE CD/CDR CD/CDR
SBR SBR OUT OUT IN IN OUT OUT IN IN OUT OUT IN IN OUT OUT
SBL SBL
R R L L R R L L R R L L
FRONT A FRONT A FRONT B FRONT B SURROUND SURROUND CENTER CENTER
SBR SBR
FRONT A OR B,CENTER, SURR,SURR BACK : 6-8 OHMS FRONT A OR B,CENTER, SURR,SURR BACK : 6-8 OHMS
FRONT A + B : 8 OHMS FRONT A + B : 8 OHMS SPEAKER SYSTEMS SPEAKER SYSTEMS
GND
+12V
GND
Signal
INPUT INPUT 1(TV)
TV( ( 1 1 ) ) TV DVD DVD( ( 2 2 ) ) VCR IN( ( 3 3 ) ) VCR IN VCR OUT VCR OUT DSS DSS( ( 4 4 ) ) MONITOR OUT MONITOR OUT Y Y C C / / P P
B B B
INPUT 2(DVD) INPUT 2
DIGITAL DIGITAL FLASHER IN FLASHER IN FLASHER IN FLASHER IN REMOTE CONT. REMOTE CONT.
DIGITAL IN DIGITAL IN
REC/ZONE B REC/ZONE B
IN IN
4 4 5 5
1 1 2 2 3 3
OUT OUT DC OUT DC OUT DC OUT DC OUT OUT OUT
AC OUTLETS AC OUTLETS
120V 120V 60Hz 60Hz
R R L L
UNSWITCHED UNSWITCHED
1.25A 150W 1.25A 150W
SURROUND BACK SURROUND BACK SWITCHED SWITCHED
SPEAKER C/ SPEAKER C/ 1.25A 150W 1.25A 150W
ZONE SPEAKER A ZONE SPEAKER A
s d