Marantz SR6003 User Manual page 72

CHECKING THE CODE
1.
1.
1.
Press and hold down the SOURCE button for
appliance which should be controlled and press
SET button until the indicator blinking twice then
back light fl ushes.
2.
Press the INFO button.
The indicator will blink twice.
3.
To setup code for all digits is displayed on the
LCD in 3 seconds.
RESETTING THE CODE
1.
2.
1.
3.
2.
4.
1.
Press and hold down the SOURCE button
for appliance which should be controlled and
press SET button until the indicator blinking
twice.
Then back light fl ushes.
2.
Press the below codes to reset.
TV : 1000
DVD : 2000
CD : 3000
DSS : 4000
Note:
After this procedure, the selected SOURCE button is
set initial code.
LEARN MODE
This remote controller is capable of learning and
storing codes used by other remote controls that you
already own.
For codes which are not learned, the remote
controller will transmit either the Marantz preset
codes from the initial settings, or remote codes from
another manufacturer's AV equipment which is set
by the customer.
The receiver sensor for the remote controller signals is
located at the top of the remote controller.
Notes:
• This remote controller is capable to learn around 120
codes.
• When the batteries are getting weak , the learning
procedure is not successful.
LEARNING PROCEDURE
1.
Place the remote controller so that its infrared
signal transmitter is facing the infrared signal
receiver on the Marantz remote controller at a
distance of about 0.05 m (2 inches).
2.
Press and hold down the SET and SETUP
buttons until LEARN indicator blinks.
3.
Select the SOURCE button to select the
SOURCE, the SOURCE name is displayed on
the LCD.
ENGLISH
4.
Select the button to be learned.
• LEARN indicator stop to blink.
Notes:
• The learning function is unavailable for all SOURCE
buttons and HDMI button in any mode.
• The learning function is unavailable for all buttons
in TUNER mode and AMP mode.
5.
Press and hold the button of the original remote
controller to learn until "OK" is displayed on the
LCD.
• When "NG" is displayed on the LCD, repeat
this step.
• When the memory of the remote controller
is full, "FULL" is displayed on the LCD. If you
want to learn the code, you should erase
other learned button.
6.
4 5
Repeat steps and to learn other buttons in
same SOURCE.
7.
3 6
Repeat steps to to learn other SOURCE.
8.
When you have finished programming the
remote controller, press the SET button, then
LEARN indicator stops blinking and exits from
the LEARN mode.
Notes:
• When "NG" is displayed on the LCD once again,
the transmitting code is unavailable for remote
controller, or the transmitting signal is intercepted
by noise.
• If no buttons are pressed for approximately 1 minute
while in the LEARN mode, the remote controller
automatically exits from the LEARN mode.
69