Control Panel And Doors; Ovens; The Tall Oven - Rangemaster Arleston 90 Dual Fuel User's Manual & Installation Instructions

Fig. 5.5
ArtNo.330-0003 - Grill pan w handle pulled forwards
Fig. 5.6
ArtNo.320-0002a Proplus oven door side screws
Fig. 5.7
Fig. 5.8

Control Panel and Doors

Avoid using any abrasive cleaners, including cream cleaners.
For best results, use a liquid detergent or use a soft cloth
wrung out in clean hot soapy water.
You can use the same method for cleaning the control panel
and knobs. After cleaning, polish with a dry cloth.
Glass Fronted Door Panel
The oven door front panels can be taken off so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the 'Moving the Cooker' section under
'Installation').
Open the oven door slightly and remove the front panel
fixing screws from the door sides, two each side (Fig. 5.6).
Carefully lift off the outer door panel. The inside face of the
glass panels can now be cleaned – take care not to disturb or
wet the door insulation.
Note: If the door is triple glazed then the inner two panels are
fixed together and should not be separated. After cleaning,
carefully refit the outer door panel and replace the side fixing
screws.
DO NOT use harsh abrasive cleaners or sharp metal
n n
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.

Ovens

'Cook & Clean' Panels
The main oven has panels which have been coated with a
special enamel that partly cleans itself. This does not stop
all marks on the lining, but helps to reduce the amount of
manual cleaning needed.
The 'Cook & Clean' panels work better above 200 °C. If you do
most of your cooking below this temperature, occasionally
remove the panels and wipe with a lint free cloth and hot
soapy water. The panels should then be dried and replaced
and the oven heated at 200 °C for about one hour. This will
make sure the 'Cook & Clean' panels are working effectively.
DO NOT use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.
Removing the Main Oven Linings
Some of the lining panels can be removed for cleaning.
If you wish to clean the enamel interior of the oven, you
will need to remove the shelves before removing the 'Cook
& Clean' panels. You do not have to remove the support
brackets to remove the panels. Lift each panel upward and
slide forward off the support brackets (Fig. 5.7).
Once the panels have been removed, the oven enamel
interior can be cleaned. Refit in the reverse order.

The Tall Oven

To clean the oven sides, slide out the shelves, unhook the
supports from the oven sides, and lift out (Fig. 5.8).