D-Link DSL-2740U User Manual page 37

Section 3 – Web Configuration

Adding a channel in DHCP(Static IP) mode, do as follow:
Step 1 Set the Default Route Selection to Specified.
Step 2 Set the channel mode to DHCP(Static IP).
Step 3 According to the internet service provided by your ISP, choose the
WAN connection type. For dynamic IP user, choose DHCP. For static
IP user, choose Fixed IP.
Step 4 If the Type is set to Fixed IP, enter the Local IP Address, Remote IP
Address, and Netmask provided by your ISP.
Step 5 After setting, click Add to add the new channel.
After adding a channel to the table, click
shown in the following figure appears. In this page, you can modify parameters of
this channel in PPPoE mode.
D-Link DSL-2740U User Manual
in the PPPoE mode, the page
35