D-Link DSL-2740U User Manual page 27

Section 3 – Web Configuration
The following table describes the parameters and buttons of this page:
Field
Protocol It displays the protocol type used for this WAN
connection.
ATM VCC The ATM virtual circuit connection assigned for this
PPP interface (VPI/VCI).
Login Name The user name provided by your ISP.
Password The password provided by your ISP.
Authentication You can choose AUTO, CHAP, or PAP.
Method
Connection You can choose Continuous, Connect on Demand,
Type or Manual.
Idle Time (s) If choose Connect on Demand, you need to enter the
idle timeout time. Within the preset minutes, if the
router does not detect the flow of the user continuously,
the router automatically disconnects the PPPoE
connection.
Bridge You can select Bridged Ethernet, Bridged PPPoE, or
Disable Bridge.
AC-Name The accessed equipment type.
Service-Name The service name.
802.1q You can select Disable or Enable. After enable it, you
need to enter the VLAN ID. The value ranges from 1 to
4095.
MTU Maximum Transmission Unit. Sometimes you must
modify this function to access network successfully.
Static IP If this function is disabled, the modem obtains an IP
address assigned by an uplink equipment such as
BAS, through PPPoE dial-up. If this function is enabled,
the modem uses this IP address as the WAN IP
address.
Source Mac The MAC address you want to clone.
address
MACCLONE Click it to enable the MAC Clone function with the MAC
D-Link DSL-2740U User Manual
Description
25