D-Link DSL-2740U User Manual page 19

Section 3 – Web Configuration
Step 1 Click Setup Wizard. The page is shown as the figure appears on the
right. There are 5 steps to configure the device. Click Next to continue.
Step 2 Change the Login password (The default Login password is admin.),
and then click Next.
Step 3 If you do not change the Login password, click Skip to go to the next
page.
Step 4 Set the system time and mode, and then click Next.
Step 5 In this page, you can set the WAN interface.
Step 6 There are types of Protocols to connect to internet in the drop-down
list of protocol. According to your subscribed service from your ISP,
select the protocols.
D-Link DSL-2740U User Manual
17