Operation - Marantz PM7200 User Manual

@3
CLASS A SWITCH
Press this switch while amplifier power is turned off to switch between
Class A (25W, 8 ohms) and Class AB (95W, 8 ohms) amplifier operation.
The CLASS A indicator is lit while CLASS A operation is selected, and
Class AB operation is indicated when the CLASS A indicator is not lit.
IMPORTANT:
The top cover may become hot during CLASS A operation, but this
does not indicate malfunction. Note, however, that you should never
place anything on top of this amplifier. Doing so can block ventilation
holes, resulting a build up of heat and malfunction of or damage to
the amplifier.
@4
SPEAKER SWITCHES 1/2
Use these switches to turn speaker output on (depressed) and off
(raised). You can turn off speaker output when listening to output
over headphones.
@5
PHONES JACK
Use the jack to plug in headphones that are equipped with a
standard phone jack.
@6
STANDBY INDICATOR
This indicator is lit while the amplifier is in the Standby Mode. Press-
ing the remote control unit's POWER buttons switches the amplifier
between standby and power on.

OPERATION

1
INTEGRATED AMPLIFIER PM7200
INPUT SELECTOR
POWER ON/OFF PHONES STANDBY 1 SPEAKERS 2
ON OFF
Perform the applicable operation on the connected
equipment.
TO PLAY AN ANALOG RECORD
1. Set INPUT SELECTOR to PHONO.
2. Play the record on the turntable.
3. Use VOLUME to adjust volume, and BASS and TREBLE to ad-
just the tone.
NOTE:
• Be sure the set VOLUME to is minimum setting before placing
the stylus onto the record or before replacing the turntable's car-
tridge.
• Never subject the turntable to shock or vibration while a record
is playing. This can cause the stylus to jump and possible
damage the record.
• Locating your turntable too close to the speakers can cause howl-
ing, which will make it impossible to use higher volume settings.
• Never turn off power while the stylus is in contact with the surface
of the record.
TO LISTEN TO AN FM/AM BROADCAST
1. Set INPUT SELECTOR to TUNER.
2. Tune in the desired station on the tuner.
3. Use VOLUME to adjust volume, and BASS and TREBLE to ad-
just the tone.
TO PLAY A COMPACT DISC
1. Set INPUT SELECTOR to CD.
2. Play a CD on the CD player.
3. Use VOLUME to adjust volume, and BASS and TREBLE to ad-
just the tone.
TO PLAY EQUIPMENT CONNECTED TO THE AUX 1 OR
AUX 2 JACKS
1. Set INPUT SELECTOR to AUX1 or AUX2.
2. Set up the connected equipment for play.
3. Use VOLUME to adjust volume, and BASS and TREBLE to ad-
just the tone.
5
3
VOLUME
TAPE PHONO CD TUNER AUX1 AUX2 CD-R/MD
TAPE MUTE CD-R/MD
MIN
REC SELECTOR
BASS TREBLE BALANCE
OFF
CLASS A SOURCE DIRECT
SOURCE TAPE CD-R
CD-R TAPE
COPY
- + - + ON OFF ON OFF L
R
3
MAX