Table of Contents
Advertisement
2. Lift open the camera shroud by flipping it down
and away from the front of the camera. The
front of the camera is indicated by the lens
location.
3. Adjust the tilt of the camera by loosening the tilt
angle lock screw as shown in
pivoting the lens position to the desired range.
When finished, lock down the camera tilt angle
by tightening the tilt lock screw.
4. Adjust the field-of-view and focus rings to
achieve the desired result. Be sure to lock the
lens ring thumbscrews by tightening them down.
5. Alliance is equipped with a secondary analog video
port, RCA type, which can be found next to the reset/reboot buttons. This analog
port utilizes IQinVision's exclusive IQfocus utility which allows precise focusing of
the camera. Note that IQfocus shuts off 5 minutes after Alliance is powered up or
immediately after Alliance begins sending its digital stream.
NOTE: The lens on Alliance cameras are fixed iris and therefore no iris
adjustment is needed.
11. Reboot and Factory Restore
Rebooting - Depress the reboot key for 2 -3
seconds then release.
Restoring to Factory Default - While
pressing the "Factory" key, press and hold
the "Reboot" key for 2-3 seconds. Keep
holding the Factory key for 10 seconds,
then release.
Figure 10.1
and
8
Tilt Lock Mechanism
Figure 10.1
Factory
Reboot
Figure 11.1
Advertisement
Table of Contents
