Table of Contents
Advertisement
In addition, follow local regulations and laws that may have specific
requirements governing the installation of security equipment on a ceiling tile
surface. IQinVision also strongly recommends the use of a ceiling tile brace and
other mounting hardware designed to secure your Alliance to the ceiling frame
infrastructure.
9. Connect Camera
1. If 12-24V DC or Input/Output connections are required, be sure to attach the
supplied male connector to the appropriate wiring coming from the head end.
2. Connect Ethernet, aux power & I/O, and analog video out connections as
appropriate between the camera and the head end. If you are using 12-24V DC
power, pay careful attention to the polarity markings on the connector and make
sure they match the polarity of your power leads.
3. (H.264 variant only) Connect audio cables to the supplied 3.5mm audio jacks.
4. Carefully feed the connected wires one at a time back through the pass through
hole.
5. Carefully snap the camera assembly to the mounting ring by first sliding one of
the removal tabs under the attachment lip of the mounting ring then firmly pivot
the other two mounting tabs into the mounting plate. The camera mount tabs
should snap into place.
10. Camera Positioning, Field-of-View
Set-up and Focus
NOTE: Camera positioning, field-of-view and focus set-up can be assisted by
connecting an analog test monitor to the installation/set-up RCA port on the
side of the camera.
1. Determine camera pan direction by gripping the camera assembly near the
mounting plate, carefully pivot the camera to the approximately correct pan
direction.
7
Advertisement
Table of Contents
