GEA FK40/390 K Maintenance Manual page 48

12 I Assembly of compressor
9
Fitting the shaft seal
Position in Parts list position: 2010
parts list
Tools: Allen key 6 mm
Working course
INFO
- Push the compression spring onto the crankshaft. Rotate the spring until the driving catch is engaged in the
crankshaft
- Push the guide ring with O-ring and sliding ring onto the crankshaft. Rotate all parts until the spring is enga-
ged in the guide ring. Avoid scratches on the sliding ring!
880
- Install the shaft seal cover with the gasket. The inscription „TOP" must be at the top
750
- Press the shaft seal cover onto the bearing flange and tighten the screws
2050
- Turn the crankshaft by hand
2110
- Install the leak oil collection device (only up to type code 013 and see also under service-kits:
Leak oil collection device)
48
Caution! Avoid damages! Pay attention to the markings! ly a little oil to the parts!
Observe tightening torques!
Leak oil collection device
34 Nm